Transfer Paper Instructions:
- Place transfer paper colorful side down on a slab of clay. We recommend white clay for the best results and the most accurate colors.
- Roll your acrylic roller over the transfer paper several times and make sure that the transfer paper is very well stuck to the clay and there are no air pockets. (Tip to avoid air pockets: place your roller in the middle of the transfer paper and then slowly roll it towards the end in both directions)
- Run transfer paper under the faucet in your sink with a gentle stream of water. Gently rub all the excess paper off using your fingers. Don't apply too much pressure, just slide your fingers until you reach a smooth texture. Too much pressure can distort your image.
- Let it dry just a bit before cutting your slab but don't cure the clay until it's fully dry.
- Bake in your oven as usual. Keep in mind that the colors might slightly change while baking.
- You don't need to seal your clay pieces but you can do it for increased durability. We recommend resin for a glossy finish and DuraClear Ultra Matte for a matte look.